Description
Power your entire residence on or off-grid with the 15 kWh Outback Power SystemEdge 514PHI with the 5kW SkyBox inverter and SimpliPhi batteries. This pre-bundled battery-based energy package is part of the SystemEdge Suburban series by Outback. The high capacity battery bank stores up to 15 kWh of nameplate energy storage. The DC-coupled 5kW Skybox grid-tie/battery hybrid inverter delivers 5kW of continuous power per second. This system uses DC coupling for both the solar and the connection to the battery system for greater overall efficiency. This all-in-one power management and battery storage package is designed to provide backup power in the event of a grid outage and to support time-of-use optimization.
Featuring the 5kW SkyBox Hybrid Inverter and four (4) SimpliPhi 3.8kW Lithium Ferro Phosphate (LFP) batteries, the SystemEdge 514PHI can provide up to six hours of battery backup power. The SimpliPhi batteries are engineered for optimal float service performance. Each Simpliphi battery includes an integrated battery management system (BMS) which regulates the batteries ensuring they operate at optimal efficiency. The built-in circuit breaker protects the battery system from short circuits. PV solar system powers loads and charges batteries during the day, while the daily-cycled batteries power loads when the sun sets and grid power is expensive. The SystemEdge 514PHI can provide power and storage to support loads consistent with a modern residence made up of a refrigerator, computer, multiple TVs, and lighting.
Designed for convenience, value and flexibility, the Outback Power SystemEdge pre-bundled packages take the guesswork out of selecting the right combination of power electronics and energy storage. The Outback Power SystemEdge 514PHI package includes a factory pre-wired and tested 5kW SkyBox True Hybrid Energy System, 4 SimpliPhi 3.8kW batteries, 2-shelf Integrated Battery Rack (IBR), SkyBox Rapid Shutdown, OPTICS RE web enabled monitoring and control, 1 pair of 200A external CTs, 1 fire raptor shutdown switch and 24V shutdown replay, and all necessary connection hardware. The 5kW SkyBox True Hybrid Energy System is designed for a clean balance-of-systems, all in one box, allowing for fast and easy installation. The Outback Power advanced technology allows for remote system control and monitoring available through any internet-enabled device with OPTICS RE.
Quality and reliability from Outback Power assures customers receive the best technologies for renewable energy systems in the market today. The fully integrated design of the SkyBox system eliminates external charge controllers and communication boxes, significantly cutting installation time and cost. Simply hang the system on the wall with included brackets, make the necessary connections, and the SE-SB-514PHI system is fully operational. Backed by a 5-year standard warranty. Order online or by PHONE 888-498-3331
- All-in-one package delivers up to 5,000 Watts of continuous power
- Power a modern load continuously running a refrigerator, computer, lights, and multiple TVs
- Advanced Grid/Hybrid technology allows for grid-interactive and stand-alone capability in one unit
- Factory tested, pre-wired and pre-configured for fast installation
- Simpliphi batteries utilize Lithium Ferro Phosphate (LFP) battery technology
- 2-shelf Integrated Battery Rack (IBR-2-48-175-Li)
- Skybox Rapid Shutdown
- Single brand UL and NEC compliant system
- OPTICS RE System monitoring and control
- Made in the USA
Videos
View AllCloseParts / Specifications
5KW OUTBACK POWER SKYBOX INVERTER SPECIFICATIONS: |
5KW OUTBACK POWER SKYBOX INVERTER SPECIFICATIONS |
TYPE: |
String Inverter |
TOPOLOGY: |
Transformerless |
GRID AND LOADS: |
----- GRID AND LOADS ----- |
AC VOLTAGE: |
120/240V (split-phase) |
AC FREQUENCY: |
60Hz |
MAX CONTINUOUS AC OUTPUT POWER (@45°C): |
5000VA (derate above 45°C) |
MAX CONTINUOUS OUTPUT CURRENT (@ 240V): |
24A @ 25°C |
TOTAL HARMONIC DISTORTION: |
Typical: <2% Maximum: <5% |
INTEGRATED ARC FAULT DETECTION, GROUND FAULT DETECTION & ISOLATION AND MONITORING: |
Yes |
POWER FACTOR AT RATED POWER: |
1 |
PV INPUT: |
----- PV INPUT ----- |
MAX PV SYSTEM VOLTAGE: |
600V |
MPPT VOLTAGE RANGE: |
200-600V |
MAX INPUT CURRENT: |
20A |
MAX SHORT-CIRCUIT CURRENT: |
32A |
MAX BACKFEED DURATION (TO ARRAY): |
<8ms |
REVERSE-POLARITY PROTECTION: |
Yes |
CEC WEIGHTED EFFICIENCY: |
>94% |
TYPICAL INVERTER EFFICIENCY: |
>97% |
TRANSFORMERLESS, UNGROUNDED: |
Yes |
UNASSISTED LOAD SUPPORT FROM BATTERY ONLY: |
5000VA |
INVERTER - NOMINAL DC BATTERY VOLTAGE: |
48V |
INVERTER - BATTERY VOLTAGE RANGE: |
42-60V |
INVERTER - REVERSE-POLARITY NOTIFICATION: |
Yes |
IMMEDIATE BATTERY BACKUP POWER: |
Yes |
GRID SUPPORT (UL 1741 SA): |
Yes |
ISLANDING PROTECTION: |
Yes |
NET METERING: |
Yes |
NON-EXPORT: |
Yes |
MAXIMUM INDEPENDENCE: |
Yes |
CONFIGURABLE BATTERY CHARGING PARAMETERS: |
Yes, to allow/disallow charging from AC for compliance with local regulations |
PRIORITIZED CHARGING FROM RENEWABLES: |
Yes |
LISTINGS/CERTIFICATIONS: |
UL 1741 SA, CSA 22.2 No. 107.1, UL 1778, HECO Rule 14H SRD, CA Rule 21 SRD, IEEE 1547-2003, IEEE 1547.1-2005 |
ROHS: |
Yes, directive 2011/65/EU |
WEIGHT (LB/KG): |
110.6 lbs / 50.2 kg |
DIMENSIONS H X W X D (IN/CM): |
47 x 21 x 9.4 in / 119.4 x 53.3 x 23.9 cm |
FIELD-UPGRADABLE FIRMWARE: |
Yes |
CHASSIS TYPE: |
NEMA 3R |
SIMPLIPHI 3.8 Battery Specifications: |
----- SIMPLIPHI 3.8 BATTERY SPECIFICATIONS ----- |
CHEMISTRY: |
Lithium Ferro Phosphate (LFP), The safest Lithium Ion chemistry available, No cobalt or risk of thermal runaway |
OCPD: |
Built-in, accessible 80 Amp DC breaker on/off switch |
BMS: |
Built-in Battery Management System |
COMPATIBILITY: |
Compatible with all industry standard inverters and charge controllers |
MAINTENANCE: |
Maintenance-free, No ventilation, cooling or thermal regulation required |
Rated kWh Capacity: |
3.8 kWh DC @ 100% DOD, 3.04 kWh DC @ 80% DOD |
MAX Discharge Rate (10 minutes): |
60 Amps DC |
MAX Continuous Discharge Rate: |
45 Amps DC |
MAX Continuous Charge Rate: |
45 Amps DC |
Depth of Discharge: |
up to 100% |
Charging Temperature: |
32° to 120° F (0° to 49° C) |
Storage Temperature: |
6 months: 14° to 77° F (-10° to 25° C), 3 months: -4° to 113° F (-20° to 45° C) |
Self-Discharge Rate: |
< 1% per month |
Cycle Life: |
10,000+ cycles (@ 80% DOD) |
Memory Effect: |
None |
Warranty: |
10 Years or 10,000 cycles (@ 80% DOD) |
Weight: |
78.24 lbs. (35.5 kg) |
Dimensions (W x H x D): |
13.5 x 14 x 8 in. (15.5” H w/terminals) / 0.88 ft3 (34.3 x 35.6 x 20.3 cm / 0.025 m3 ) |
IBR-2-48-175-Li Battery Rack SPECIFICATIONS: |
----- IBR-2-48-175-Li BATTERY RACK SPECIFICATIONS ----- |
Dimensions H x W x D (in/cm): |
33 x 27 x 24.5 / 83.8 x 68.6 x 62.2 |
Weight w/out Batteries (lb/kg): |
60 lb / 27 kg |
Physical Characteristics: |
0.125-inch thick aluminum enclosure with FLEXware silver finish; plated copper bus bars and clear protective covers. Ships fully assembled (except for batteries) |
String Overcurrent Protection: |
175ADC |
Gauge of Conductors: |
4 AWG, 1/0 AWG |
Capacity: |
Up to 4 48V lithium ion batteries |
Nominal System Voltage: |
48VDC |